Prefilling machine new horizontal design, light and convenient, automatic pumping, for thick paste can be added hopper feeding. Manual and automatic switching function: When the machine is in the "automatic" state, the machine will automatically carry out continuous filling according to the set speed. When the machine is in the "manual" state, the operator steps on the pedal to achieve filling, if it has been stepped on, it will also become automatic continuous filling state. Anti - drip filling system: the cylinder moves up and down when filling, driving the dull head.
Common faults and solutions of prefilling machine:
(1) irrigation dissatisfaction
Causes :1) the valve is inactive, stuck, and the water valve is not opened; 2) The small hole of the return pipe is blocked by water, and the return air in the bottle is not smooth; 3) The rubber in the contact part between the valve port and the bottle is damaged, and the water flow is not smooth.
Elimination method :1 Open the valve to check the spring and water valve rubber ring; 2) There is no water cap on the return pipe, check it, and it can be adjusted up and down; 3) Replace the sealing rubber.
Slurry is pumped when bottle leaves valve port
Causes :1) The air valve is not closed, which is the main reason; If the air valve is not closed, it will also breathe and spray when there is no bottle. 2) The "O" seal ring with a diameter of 8mm in the valve is damaged so that the valve cannot be closed; 3) The vent position is wrong; 4) Process problems (sugar temperature and pressure).
Elimination methods :1) the fork pressing block and cylinder on the fork shaft sleeve friction is too small, the valve has rebound, close the valve position behind the upward pressure, increase the friction to overcome rebound can :2) change the rubber ring, pay attention to i o, the ring is very key, should be soft and elastic; 3) After the filling is full, the bottle should be discharged until the excess gas rises from the bottom of the bottle to the mouth of the bottle; 4) Adjust beverage technology.
(3) Insufficient leakage of the air release valve
Causes :1) the "0" sealing ring is damaged; 2) Deformation of the reset spring.
Elimination method :1) Replace the "O" ring; 2) Replace the spring.
(4) The machine is not running smoothly
Causes :1) the spring box shaft wear key and shaft stuck hair; 2) Roller off or bearing wear; 3) Wear of large worm gear; 4) Motor failure.
Elimination method :1) check the spring box; 2) disassemble and replace bearings and rollers; 3) Check and disassemble worm gear; 4) Check the motor.
(5) The bottle is not smooth
Causes :1) the transport chain is not stable; 2) The arc of the dial plate does not match.
Elimination methods :1) check and repair; 2) Replace.