Oral liquid filling mill is a kind of linear continuous filling and capping machine, mainly used in the pharmaceutical industry for the filling and capping of 10-30ml and 50-250ml glass bottles and plastic bottles. It can automatically complete the whole production process from the transmission of the bottle into the bottle, the bottle into the bottle, the dial wheel to deliver the V-shaped block parts, filling, capping, rolling (rotating) the cap to the bottle out. This machine can not only be used as a single machine, but also can be used as a linkage line with cleaning machine and sterilization drying machine.
The equipment filling and rolling cover two in-one, compact structure, clear and clear small volume, fewer specifications, easy to replace specifications. Can fill all types of liquid; Such as: water-based liquid, oral sugar, paste, honey, alcohol or type of solvent, suspension, etc. It is suitable for the cylinder, also suitable for the glass bottle container and plastic bottle container filling rolling (rotating) cap, has a strong adaptability, widely used in medicine, food, chemical industry, can be used alone or linked with other single machine, especially suitable for the pilot production workshop of scientific research institutes and aseptic filling of pharmaceutical enterprise preparation workshop.
The equipment belongs to the electric cover rolling machine, the whole machine is novel, beautiful, reasonable design, lightweight. Table and protective cover are made of stainless steel material, roller strength, wear resistance, long service life, rolled bottle aluminum cover sealing good. Suitable for oral liquid bottle aluminum cap, 2 ml bottle aluminum cap, wife oral liquid bottle aluminum plastic cap, penicillin bottle aluminum cap, spray tube aluminum cap, spray tube aluminum cap and other rolling caps. It is an ideal cover rolling equipment for mass production in major hospitals, pharmaceutical factories and scientific research.
Because the machine is equipped with a number of rolling caps, the rolling caps can be selected according to the size of different bottle caps. Try the bottle before use.
1. If the lid is not rolled tightly, you can unscrew the locking nut of the rolling lid and unscrew the upper rolling lid in the counterclockwise direction, and then lock the fixing nut.
2. The cap is rolled too tightly, and there is the phenomenon of rotary cutting the cap. Screw the upper rolling cap locking nut into the upper rolling cap in a clockwise direction, and then lock the upper fixing nut.
3. If the lower edge of the bottle cap is not tight, the eccentricity of the three gin heads can be reduced according to the actual situation. If it is too tight and the bottle is crushed, the eccentricity of the three gin heads can be adjusted appropriately.
Adjustment of the upper arm
This machine can be used for rolling 5-500ml bottle caps. When rolling bottles of different specifications, just put the bottle of this specification on the tray, hold the transverse arm with one hand, and loosen the nut on the left of the transverse arm with the other hand to make the transverse arm fall or rise. When the rolling cap and the bottle cap are about 20mm, tighten the nut, and then use the random hex wrench to tighten the supporting ring against the horizontal arm and then lock the supporting ring. (Note) When tightening, ensure that the position of the cap and cap is aligned.
Adjustment of V-shaped support block
Place the bottle into the lower V-shaped support, loosen the two screws on the support block, move the bottle and the lower V-shaped block together until the rolling cap is aligned with the bottle cap, and tighten the two screws on the V-shaped block.
Specific operation method of the equipment:
1. Put the bottle filled with liquid and capped on the lower tray, lean on the V-shaped support block, hold the bottle with one hand, and pull the handle downward with the other hand. At this time, the tray supports the bottle and lifts it upward until the bottle cap and the rolling cap are compressed.
2. When the bottle cap and the rolling cap are pressed, the three rolling cap cutter heads rotating continuously for several turns will roll the bottle cap tightly. (Note) The motor must run clockwise.
3. Push the handle forward so that the rolled lid returns to its original position with the tray. The whole operation process is completed.