The medical transfer window is an air purification device installed on the wall of a hospital. It is usually installed on the wall of an operating room or a negative pressure ward. It is used to transfer living or medical items. It can reduce the number of people entering and leaving, and reduce the impact of personnel on the clean room. Pollution.
Due to the different usage scenarios, the medical transfer window not only needs to have a purification function, but also needs to have a sterilization and disinfection function, so how does the medical transfer window realize the disinfection function? The following describes how the medical transfer window realizes the disinfection function.
In the design of the medical transfer window, in addition to the self-cleaning function, lighting function, etc., an ultraviolet germicidal lamp is installed inside, which can sterilize the interior of the transfer window during the transfer process. Equipped with a disinfection port and a verification port, and disinfect the interior by injecting disinfection gas into the transfer window.
The sterilization process of the ultraviolet lamp is relatively simple: open the medical delivery window, put the delivered items in, close the door, and activate the ultraviolet lamp. After the sterilization is completed, the ultraviolet lamp is turned off and the opposite door can be opened. The sterilization time of the UV lamp is set to 30 seconds at the factory, and other times can be set according to the site conditions.
The disinfection of the medical transfer window is achieved through the disinfection port. When disinfection is required, close the double doors of the transfer window, connect the disinfection equipment to the disinfection port, start the disinfection equipment, and disconnect the interface after the disinfection process is over. The transfer window can be operated sequentially.
The medical transfer window is not much different from the ordinary transfer window. The operation process is basically the same, but the process of sterilization and disinfection is added. In addition, due to the environmental requirements of the medical transfer window, the material of the medical transfer window is preferably stainless steel, which is corrosion-resistant and easy to clean, and is not easy to be contaminated with dust.